Specifications

Rockhopper 38 – Maintenance Manual
183
AP-74038, Rev. 1.1, 25/01/05
8.2.5. Replacing the blades
Please follow the procedure below to install the new blades, which has to be done every year as part of the
periodical services done by an authorised Mutoh technician.
Step 1 : Put the lever up.
Step 2 : Remove all the blades as shown in the picture below.
Remove previous blade (wing) Two pins on each side of the pressure roller
Step 3 : Install the new blades. Make sure that the 4 pins of the pressure roller match with the holes in the
blade.
2 holes in blade at both sides Installed blade (pins in the holes)
Step 4 : Installation of the new blades is finished.