Specifications

Rockhopper 38 – Maintenance Manual
175
AP-74038, Rev. 1.1, 25/01/05
8. MAINTENANCE
8.1 TRANSPORTING THE PRINTER
This section explains the procedure for moving a printer which is in use to another floor in the same building
or to another building.
8.1.1 How to move on the same floor or by elevator to another floor
A serviceman need not be present but the following procedure should be explained to the user.
Caution:
• Two people are required to move the printer.
• Cleaning is not necessary.
• Cartridges, cutter, waste fluid box may remain installed.
• Be careful to keep the printer level. If it is tilted, waste may spill from the fluid box.
Step 1 : With power off, bring the head to the home position and attach head fastening fittings with wing
screws.
Step 2 : Remove the power cable and interface cable.
Step 3 : Undo castor locks and move the printer by pushing it horizontally.
Step 4 : When the move is finished, lock the castors, turn the wing screws and remove the head fastening
fittings.