Specifications

Rockhopper 38 – Maintenance Manual
163
AP-74038, Rev. 1.1, 25/01/05
7.2.6 Install a Program (Software Upgrade)
Caution:
 Failure to switch off the power before mounting and unmounting flash memory card
may cause damage to the Main Board and make it impossible to install data
properly.
Step 1 : Switch off power to the printer.
Step 2 : Mount the latest program flash memory card in the slot at the back of the printer.
Step 3 : Switch on the power.
Step 4 : The following message will appear in the liquid crystal display:
Erase
Copy
Compare
End
The buzzer will sound. (It will end after about 70 seconds)
Step 5 : Switch off power to the printer.
Step 6 : Remove the flash memory card.
Step 7 : To Verify Switch on power to the printer and verify from the initialization and panel display that
the version has been upgraded.