Specifications

Rockhopper 38 – Maintenance Manual
156
AP-74038, Rev. 1.1, 25/01/05
Step 5 : Implement the “Head Rank Input”. (Refer to “Adjusting the Capping Position”)
Step 6 : Implement the “Head Nozzle Verification”. (Refer to “Check Head Nozzles”)
Step 7 : Enter the rank of Black. (Refer to “Enter Head Rank”)
(The rank of Color will be registered as it is.)
Step 8 : For “Ink Fill”, implement “Black”. (Refer to “Enter Head Rank”)
After the ink has been filled, return to the previous level.
Step 9 : Load media in the printer.
Step 10 : Implement the “Black Head Tilt Verification”
This will make four single-pass, unidirectional printing runs. Use Head Adjuster B to bring the first
and second lines and the third and fourth lines to approximately straight lines.
Step 11 : Check the printing and move the carriage to the centre. If the first line is offset to right relative to
the second line, slide Head Adjuster B down and fasten it. If the first line is offset to left relative to
the second line, slide Head Adjuster B up and fasten it. When fastening the Print Head, push it
towards the taper of the Head Mount for depth and towards the taper of Adjuster B for tilt. (The
scale on Head Adjuster B represents a change of about 0.1 mm per graduation.)
Step 12 : Implement the “Black Head Tilt Verification”.
Repeat Steps 9 and 10 until the Black Head tilt disappears.
Step 13 : After completing the tilt adjustment, press [BACK] to return to the previous menu.