Specifications

Rockhopper 38 – Maintenance Manual
153
AP-74038, Rev. 1.1, 25/01/05
7. ADJUSTMENTS
7.1. INTRODUCTION
Adjustments and adjustments procedures required when replacing parts are explained in this chapter.
Notes:
 Refer to “Jig and tool list”
7.2 ADJUSTMENTS
7.2.1 Steel Belt Tension Adjustment
Caution:
 Steel belt are highly susceptible to breakage and end damage must e handled
carefully
Caution:
 Be careful not to cut your hands when handling the steel belt.
Step 1 : Set the steel belt in the middle of the return pulley and motor pulley
Step 2 : While moving the cursor left and right, turn the return pulley adjustment screw until the steel belt
does not tend to come off the pulley or move across the pulley.