Specifications

Rockhopper 38 – Maintenance Manual
151
AP-74038, Rev. 1.1, 25/01/05
6.3.3.1.
Request correct MAC address
Step 1 : Remove the Right Cover.
Step 2 : Remove the Ethernet Board Cover.
Step 3 : Onto the installed card you can see a sticker with a ‘FM0 number’.
Notes :
Write down this number ‘FM0 xxxxxx’. Important are the 6 digits ‘x’.
Step 4 : Based on this number Mutoh Europe’s service department can provide you the correct MAC
address for your printer.
Step 5 : Reinstall the covers.
6.3.3.2.
Insert the MAC address into the printer
Step 1 : Power on the unit in a special mode. Press the [POWER] key to power ON the unit, while
simultaneously holding the [F1], [F3] and [Menu ↑] key.
Step 2 : The unit will start up in special mode. Following message will appear on the display.
* Counter *
Indication InitMenu
F3 →
MACaddress
Step 3 : Press the [F3] key to select the option ‘MAC Address’. Following message will appear on the
display.
* MAC address *
Input Password
Step 4 : Press the [F2] key.
Step 5 : Press the [F3] key.
Step 6 : Press the [F1] key.
Step 7 : Press the [F4] key.
Step 8 : The password has been inserted. Use the [F1], [F2], [F3] and [F4] key to insert the MAC
address.
Step 9 : Press the [ENTER] key to confirm.
Step 10 : Press the [POWER] key to power OFF the unit.