Specifications

Rockhopper 38 – Maintenance Manual
150
AP-74038, Rev. 1.1, 25/01/05
6.3.2. Counter Initialization Menu
This menu initializes the life counters. The parameters that can be initialized in this menu are as follows.
Diagnosis item Description
Number of prints
initialization
Initializes the total number of printing counter.
Ink initialization Initializes the ink capacity counter.
Waste ink initialization Initializes the waste fluid tank service life counter.
Head error reset Resets critical trouble errors due to over-current flowing the head.
Ink ID mask initialization Resets the ink ID mask.
Total initialization Initializes the service life counter.
NVRAM initialization Initializes NVRAM.
Timer initialization Initializes the timer.
Cutter initialization Initializes the cutter cumulative counter.
CR motor initialization Initializes the CR motor service life counter.
PF motor initialization Initializes the PF motor service life counter.
Cleaning initialization Initializes the cleaning wiper service life counter.
Head unit 1 initialization Initializes the head 1 nozzle service life counter.
Head unit 2 initialization Initializes the head 2 nozzle service life counter.
Head unit 3 initialization Initializes the head 3 nozzle service life counter.
Head unit 4 initialization Initializes the head 4 nozzle service life counter.
* Initialize *
PrintNumber Ink ID
WasteInk Head error
(1/4)
* Initialize *
Ink All
NVRAM Timer
(2/4)
* Initialize *
TotalCut CR motor
PF motor Cleaning
(3/4)
* Initialize *
Head Unit 1 Head Unit 2
Head Unit 3 Head Unit 4
(4/4)
6.3.3. MAC address write enable menu
It could happen that the computer cannot make connection with the Rockhopper II printer. If this is the case,
the MAC address of the Rockhopper II printer has probably been set to zero or incorrect.
To insert the MAC address into the Rockhopper II printer, please follow the instructions mentioned below.
Notes :
 For the MAC address, a unique number is assigned for each unit. Do not use this
function except when intending to recover following deletion of the MAC address.
 Please note that this procedure is only available onto the Rockhopper II printers with
following firmware version or higher.
 Rockhopper II : V2.00