Specifications

Rockhopper 38 – Maintenance Manual
138
AP-74038, Rev. 1.1, 25/01/05
5.6 TEST PRINTING
This procedure is used for test printing. The items are as shown below. For adjustment parameter prints, if
no serial number has been entered, a serial number will be requested. Online data signal reception is always
enabled but no signals are transmitted during the processing of a hidden diagnostic sequence.
Item Details
Normal Normal Cleaning (wiping)
Powerful Powerful Cleaning (wiping and rubbing)
Procedures from the selection of items from panel and terminal are shown below.
5.6.1 Head Printing Verification
This procedure is used to print the head nozzle verification pattern and adjustment parameters.
Panel
After the adjustment pattern printing has been finished, “END: ChkNozzles” will appear.
5.6.2 Adjustment Parameters
This procedure is used to print firmware adjustment parameters.
Panel
Adjust Param Print
Press [ENTER] to print firmware adjustment parameters but if no serial number has been registered,
registration will be requested.