Specifications

Rockhopper 38 – Maintenance Manual
135
AP-74038, Rev. 1.1, 25/01/05
5.4.13 How to make a Test Print
This procedure is used to check adjustments by printing a test pattern. it also prints adjustment parameters
and if no serial number has been entered at that time, serial number input will be requested. Online data
signal reception is always enabled but any data should not be transmitted during the processing of a self-
diagnostic sequence.
Press [Back] after adjustment parameter printing has finished to move to “AJST: HeadWash”. At other times,
press [Back] to move to “AJST: TestPrint”
1 The display is as shown below:
MUTOH BT00000000