Specifications

Rockhopper 38 – Maintenance Manual
129
AP-74038, Rev. 1.1, 25/01/05
5.4.8 How to Adjust CW
This procedure is used for adjusting the left side (capping side) edge position for plotting and for axial
alignment of the black and color heads. The adjustment of the edge sensor position in the firmware, the
black head to color head distance, color CW printing delay (position and time) and color CCW printing delay
(position and time) is made by entering the value (positional difference) resulting from a unidirectional
adjustment print. Zone delay is not required for this adjustment print.
Press [ENTER] to update the setting. If [ENTER] is pressed at “HeadGap:” and either of the two parameters
has been changed, another adjustment print will be made. If there has been no change, the display will
move to “AJST: CW (MD)”.
Press [ENTER] to update the setting. If [ENTER] is pressed at “HeadGap:” and either of the two parameters
has been changed, another adjustment print will be made. If there has been no change, the display will
move to “Zone Delay (Not Yet Implemented)”.