Specifications

Rockhopper 38 – Maintenance Manual
127
AP-74038, Rev. 1.1, 25/01/05
5.4.7 How to Align Repeatability Printing Position
This procedure is used to align black and color normal dot and micro dot repeatability printing positions. This
involves making a bidirectional test print and from the results adjusting the CCW printing delay (position and
timing) by entering into the firmware the differences between the CW printing position and the CCW printing
position. There are separate differences for both black and color normal dots and micro dots.
If [ENTER] is pressed at “Cmy err:” and the parameter has been changed, the black and color CCW printing
delays (position and timing) will each be updated in the firmware and another adjustment print will be made.
If the parameter was not changed, “Print Start?” will be displayed.
If [ENTER] is pressed, another print will be made.
If [Back] is pressed, the display will move to “AJST: Bidirectional (MD)”.
If [ENTER] is pressed at “Cmy err:” and the parameter has been changed, the black and color CCW printing
delays (position and timing) will each be updated in the firmware and another adjustment print will be made.
If the parameter was not changed, “Print Start?” will be displayed. If [ENTER] is pressed, another print will
be made.
If [Back] is pressed, the display will move to “AJST: CW”. (Please refer to “How to Adjust CW”)