Specifications

Rockhopper 38 – Maintenance Manual
117
AP-74038, Rev. 1.1, 25/01/05
5.3.5 Encoders
This procedure is used to verify the values of X-axis (media feed) and Y-axis (carriage) from displays on the
panel or the terminal.
Press [ENTER] to shift to “EXAM: Fan” or [Back] to shift to “EXAM: Encoder”.
5.3.6 Fans
This procedure is used to verify that the fans are working by turning them on and off.
Panel keys are ignored during fan on/off display. 5 seconds after displaying Fan Off, the display will shift to
“EXAM: Fan”.
5.3.7 Ethernet Board
This procedure is used to verify the initialization of Ethernet board data.
After confirming the status of initialization of the Ethernet Board from the messages shown above, press
[ENTER] to move to “EXAM: Record”