Specifications

Rockhopper 38 – Maintenance Manual
107
AP-74038, Rev. 1.1, 25/01/05
4.9.2 Replacing the Junction Board Assembly
Step 1 : Remove the Front Cover. Refer to “Removing Front Cover”
Step 2 : Remove the Unit Panel Cover. Refer to “Removing Unit Panel Cover”
Step 3 : Remove the Y Rail Cover. Refer to “Removing Y Rail Cover”
Step 4 : Remove the Rear Paper Guide. Refer to “Removing Rear Paper Guide”
Step 5 : Open the board box. Refer to “Opening and Closing Board Box”
Step 6 : Disconnect junction cable connector J109 (INK ID).
Step 7 : Disconnect all junction board assembly connectors.
Step 8 : Remove the junction board assembly. (4 fastening screws)
Step 9 : To install removed components, reverse removal procedure.