Specifications

Rockhopper 38 – Maintenance Manual
102
AP-74038, Rev. 1.1, 25/01/05
4.8.7 Replacing the Cursor Assembly
Step 1 : Remove the Front Cover. Refer to “Removing Front Cover”
Step 2 : Remove the Unit Panel Cover. Refer to “Removing Unit Panel Cover”
Step 3 : Remove the Y Rail Cover. Refer to “Removing Y Rail Cover”
Step 4 : Remove the Right and Left Covers. Refer to “Removing Right and Left Covers”
Step 5 : Loosen the tension of the Steel Belt. Refer to “Replacing Steel Belt”
Step 6 : Disconnect connectors J204, J206, J207 and J208 from the Head Board Assembly.
Step 7 : Remove the Y cable. Refer to “Replacing Y Cable”
Step 8 : Remove the ink tubes. Refer to “Replacing Ink Tubes”
Step 9 : Remove the Head Cover. Refer to “Removing Head Cover”
Step 10 : Remove the two Steel Belt fastening screws from the Cursor Unit. Refer to “Replacing Steel Belt”
Step 11 : Remove the setscrew and remove each damper tube. Refer to “Replacing damper”
Step 12 : Remove the Cursor Plate Spring
Step 13 : Lift up the Head Board Mounting Plate and take it from the Cursor
Caution:
 Be careful not to damage the Timing Fence and Sensor which are underneath the
Head Board
Caution:
 Be careful not to touch or damage the Head Nozzles
Step 14 : To install removed components, reverse removal procedure.