User`s guide

User’s Guide Tensioning winder 30
38 AP-75104 - Rev 2.3 – 12/10/2011
Step 9 : Guide the media (1) to the empty core and tighten the media with some tape.
Fine-tune the horizontal position of the scroller (4) with the adjustment screw (3) at the side.
Step 10 : Set the winding system to “FREE” and manually turn the scroller to roll up some media.
Step 11 : Pull down the tensioning bar (2) and set the winding system back to “SET” (1).
The system will automatically go to is idle position.
Step 12 : Lower the pressure rollers of the printer
Step 13 : Enable the winding system. The swingbar will move to its initial position.
Step 14 : Initialize the media as described in the User’s Guide of the printer