User`s guide

User’s Guide Tensioning winder 30
32 AP-75104 - Rev 2.3 – 12/10/2011
4.2 SCROLLER BAR
Tools needed
• Synthetic paper strip
• Adjustment plate
• Hexagon key 3 mm
• Tape (not included in winder kit)
• Pencil (not included in winder kit)
4.2.1 Calibration
Step 1 : Raise the pressure rollers of the printer.
Step 2 : Create a straight loop with the synthetic paper strip around the scroller bar in the front.
Step 3 : Guide the other end of the strip under the pressure rollers to the back of the machine and move
the strip to the left side of the machine. Create a little tension on the strip to be sure it is straight.
Step 4 : Place the adjustment plate at the front of the printer against the pressure rollers.