User`s guide

Spitfire 100 Extreme series printers  Users Guide
99 AP-75194 - Rev. 2.2
6.2.3 [F3] - Controlling the heater elements
Step 1 : Press the [F3] key.
The printer works as follows.
By pressing the [F1] key, you will have direct access to control or change the heater temperatures.
After pressing the [F1] key in the normal status, the operation panel will mention the following:
The heater message can be one of the following:
Heater busy
Heater ready
A stands for the heater.
B stands for the fixer.
C stands for the post fixer.
D stands for the dryer.
H stands for heating (heaters are heating up).
T stands for target (heaters are on temperature).
C stands for cooling (heaters are cooling down).
O stands for off (heaters are off).
6.2.3.1 Change the heater temperature
Press the [F2] key to decrease the temperature.
Press the [F4] key to increase the temperature.
Press the [ENTER] key to confirm the requested temperature change.
Press the [CANCEL] key to leave the menu without changing the heater settings.