User`s guide

Spitfire 100 Extreme series printers  Users Guide
57 AP-75194 - Rev. 2.2
3.12.2 Transferring the printer
(1) Before the transfer
Follow the steps below to transfer the printer.
Step 1 : Make sure the printer and winding system are switched OFF.
Step 2 : Make sure the head is in the right edge position (capping position).
Step 3 : Disconnect the power cables and all other cables.
Step 4 : Higher all levelling feet.
Step 5 : Install the 2 transportation arms.
Step 6 : Transfer the printer.
Notes
The caster attached to the stand has been designed for transferring the printer during short
distances.
(2) After the transfer
Step 1 : Follow the steps below to prepare the printer to be used after the transfer.
Step 2 : Make sure that you place the printer on an adequate place
Step 3 : Connect the power cable and other cables.
Step 4 : Perform a nozzle check to check if the printer head has clogged.
Step 5 : Perform a fine adjustment of image quality.
Step 6 : Check if the winding system is still well aligned.
Caution
Before transporting the printer, contact your local Authorized Mutoh Dealer.