User`s guide

Spitfire 100 Extreme series printers  Users Guide
49 AP-75194 - Rev. 2.2
3.9 SWITCH BETWEEN INK CONFIGURATIONS.
It is possible to switch from between ink configurations. Please follow the procedure below:
Important
In case of working with another type of Mutoh ink than described in this manual, refer to the
dedicated instruction sheet added to the ink kit.
Step 1 : Remove all cassettes.
Step 2 : Discharge ALL heads for 15 seconds.
Step 3 : Insert Spitfire Cleaning Cassettes.
Step 4 : Charge ALL heads for 3 minutes.
Step 5 : Pull out all cassette
Step 6 : Discharge ALL heads for 15 seconds.
Step 7 : Put back the Spitfire cleaning cassettes.
Step 8 : Charge ALL heads for 3 minutes.
Step 9 : Remove all cassettes.
Step 10 : Discharge ALL heads for 15 seconds.
Step 11 : Use the arrow keys to change the ColorMode to 2x6 or 4x4 depending on the switch.
SetupMenu 5/7 InkManager ColorMode
Step 12 : Insert Spitfire Mild Solvent ink Cassettes, and Stabilizer liquid in case of 2x6, according to the ink
configuration label
Step 13 : Charge ALL heads for 2 minutes.
Step 14 : An Authorized Mutoh Technician has to shift or unshift head block 5 to 8.
Shifted heads are needed when printing in 4x4 mode.
Unshifted heads (in 1 line) are needed when printing in 2x6 mode.
Step 15 : Perform a nozzle check and clean if necessary until all nozzles are present.
Notes
Please refer to Charge/Discharge-chapter for more details about these functions.