User`s guide

Spitfire 100 Extreme series printers  Users Guide
43 AP-75194 - Rev. 2.2
3.6 REPLACING THE CUTTING BLADE
3.6.1 Replacement time
Replace the cutting blade under the following conditions.
a. Media cannot be cut clearly
b. When the cut edge has scuffing
3.6.2 Replacement procedure
Follow the steps below to replace the cutting blade.
Step 1 : If the printer is powered ON, verify following items:
Printing or other operations are not performed.
Make sure that the display shows the normal status.
The MEDIA SET light goes off.
Step 2 : Go to the H. Unlock menu (SetupMenu 5/7) and unlock the head.
Step 3 : Open the front cover.
Step 4 : While pressing the cutting blade holder tab, rotate the cutting blade holder lever in the direction
shown on the picture (2).
Step 5 : Take out the cutting blade (3) and insert the new cutter into the media cutting blade holder (4).
Step 6 : While slightly pressing the cutting blade holder tab, return the cutting blade lever to its original
position.
Step 7 : Close the front cover.
Step 8 : Press the [ENTER] key.
Step 9 : The carriage returns to its original position and returns to menu 6/7.
Step 10 : Cutting blade replacement has been finished.