User`s guide

Spitfire 100 Extreme series printers  Users Guide
38 AP-75194 - Rev. 2.2
3.4.3 Loading sheet media
Please follow the procedure below to load sheet media.
Step 1 : Make sure the printer is switched ON.
Step 2 : Press the [F4] key in the main menu to raise the pressure rollers or use the foot pedal of the
printer.
Step 3 : Open the front cover carefully using both handles.
Step 4 : Consider the specifications of the printer before loading a sheet:
Metrical Imperial
Maximum media width 2604 mm 102.5 in
Maximum printing width 2594 mm 102.13 in
Step 5 : Slide a sheet over the print platform, under the pressure rollers.
Step 6 : Pay attention that the sheet is loaded straight to avoid slant errors.
Step 7 : Lower the pressure rollers by pressing the F4 key or using the foot pedal.
Step 8 : Decide which kind of media measurement should be done. The following profiles are available.
Profiles
Settings
OFF Sheet
Measurement None
(*)
Left  Right  Top - Bottom
Take Up
Not used Not used
SlantCheck
No No
Cutting media possible? Yes Yes
Cut Test No Yes
Feeder speed Low High
(*)
Align media to media guide dots on the print platform. Set width in Utility menu.
Step 9 : After closing the front cover, the media initialize will start.
[F1]-key Lever UP
[F2]-key Browse through the different profiles for
media measurement
[F4]-key Start media measurement using the
selected profile in the lower left corner
Step 10 : Install media retainers if necessary as explained in next chapter.
Step 11 : Installation of a sheet is finished. You can start printing.