User`s guide

Spitfire 100 Extreme series printers  Users Guide
34 AP-75194 - Rev. 2.2
Step 9 : Install the media between the two roll units at the back of the machine. Loosen the handles to
move the roll units left and right.
Step 10 : Be sure that the media is loaded centrally. This to be sure that the media is wound up straight.
This can be easily checked by the yellow labels on the winding rails. Be sure to mount the left
and right roll unit on the same distance from the 0I0 label.
Step 11 : Install an empty core between the front roll units.
A. Make sure the core is longer than the media width.
B. Load it centrally as described in previous step
C. Install a media core brace in case the media is wider than 2 meter. This to prevent the media to
bend. Please refer to Using the media core braces-chapter.
Step 12 : Use the foot-switch to release some media on the rear.