User`s guide

Spitfire 100 Extreme series printers  Users Guide
33 AP-75194 - Rev. 2.2
3.4.2 Loading Roll media
Please follow the procedure below to install and load roll media.
Step 1 : Make sure the printer and Unwinder/Winder 100 are switched ON.
Step 2 : Press the [F4] key in the main menu to raise the pressure rollers or use the foot pedal of the
printer.
Step 3 : Open the front cover carefully using both handles.
Step 4 : Make sure both unwinder (REAR) and winder (FRONT) unit are set to MANUAL mode.
Step 5 : Consider the specifications of the printer before loading media:
Metrical Imperial
Maximum loading capacity 100 kg 220 lb
Maximum width 2604 mm 102.5 in
Inner core diameter 50.8 mm or 76.2 mm 2 in or 3 in
Step 6 : Remove the packaging of the media roll.
Step 7 : Check whether the media is inside or outside printable. This affects the installation method on
the unwinder at the rear of the machine.
Step 8 : Install a media core brace in case the media is wider than 2 meter. This to prevent the media to
bend.