User`s guide

Spitfire 100 Extreme series printers  Users Guide
18 AP-75194 - Rev. 2.2
2.1 PART NAMES AND FUNCTIONS
2.1.1 Front
N° Name Function
1 Maintenance Area
To perform a part of the daily and weekly maintenance. For example
cleaning around the heads.
A mirror has been installed to optimize sight.
2 Paper Guide Support the media during printing.
3 Front cover
This cover keeps the operator safe from the drive parts of the printer while it
is operating. Only open and or close the cover to perform following
operations.
Media set and replacement
Cutter blade replacement
Cleaning the wipers and other maintenance
In case of media jams
4 TL light switch To light up the TL lights (blue and white)
5 Operation panel
This panel is used to set operational conditions, the status of the printer and
other functions.
6
SmartChip
Management System
To control the ink volume on your printer
7 Ink compartment Sixteen slots available to install ink cassettes.
8 LED indicators
Indicates if there is a cassette in the slot below the LED and if it is empty or
not.
9 Waste bottle
To collect the waste fluid. Should be emptied according to the procedure
described in this manual.
10 Stand This stand is used to install the printer on a flat surface floor.
11
Unwinder/Winder PCB
Box
This box contains all electronics to control the unwinder winder 100 system.
12 Winder system Motorized roll-up system.
13
Unwinder/Winder
control panel
To control the complete unwinder/winder 100 system.
14 Front swingbar To adjust the tension of the media and to optimize the winding of the media.