User`s guide

Spitfire 100 Extreme series printers  Users Guide
175 AP-75194 - Rev. 2.2
7.4 WHEN MEDIA JAMS OCCUR
If the loaded media gets jammed in the printer, follow the steps below to remove the media.
7.4.1 How to remove a piece of media
Put the head in the up position with the scroller.
Step 1 : Press [F4] to raise the pressure rollers.
The MEDIA SET lamp will switch on (orange).
The following message is displayed.
Notes
For raising or lowering the pressure rollers, you can use the foot switch instead of the
operation panel.
Step 2 : If a piece of media or media dust is stocked in the printer, open the front cover carefully with the
two grips and remove the piece of media or media dust.
Caution
Be sure not to pinch your fingers while opening and closing media cover.
Threat the head with care, very fragile.
Step 3 : If there is an error requiring a restart, power the printer OFF and ON again.