User`s guide

Spitfire 100 Extreme series printers  Users Guide
169 AP-75194 - Rev. 2.2
(13) Tracing media or other thin media cannot be detected.
N° Possible cause Solutions
1 You did not use recommended media. Use recommended media.
2 You used the printer in direct sunlight or other
locations not appropriate for the specified
environment.
Use the printer in the specified environment.
(14) Media size is wrong during media Initial.
N° Possible cause Solutions
1 You did not use recommended media. Use recommended media.
2 You did not load the media straight into the printer. Load the media straight into the printer.
3 The curled surface of media is up when loading. Remove the curl in the media, or replace with
new media.
4 You used the printer in a location with air conditioner
or other location not appropriate for the specified
environment
Use the printer in the specified environment.
5 You reused printed media. Use new, not printed media.
(15) Media is crooked while printing.
N° Possible cause Solutions
1 You did not use recommended media. Use recommended media.
2 The loading position of the media is not correct. Load the media correctly.
(16) The printer is not connected to a computer using the Centronics interface.
N° Possible cause Solutions
1 You did not connect the Centronics interface cable
correctly.
Connect the Centronics interface cable
correctly.
2 When the printing data is transferred from the
computer, the DATA lamp does not lit.
If the DATA lamp does not lit, contact the
computer maker.
3 The Centronics setting on the printer does not match
the setting on the computer.
Make the Centronics setting on the printer so
that it matches the setting on the computer.
4 The type of command that is currently set, does not
match the command of a computer or a driver.
Match the command setting of the printer to
the environment of a computer or a driver.
(17) The printed lines are blurred.
N° Possible cause Solutions
1 Temperature of the fixer is low Raise the temperature
2 You did not use recommended media. Use recommended media.
3 You used too thick or too thin media. Use recommended media
4 You used bond media. Use recommended media.
5 The printed surface is not the printable side. Pay attention to the printable side to load
media correctly.
6 Did you try head cleaning? Perform head cleaning.
Perform strong cleaning.
Clean the surface of the print head.
Perform long save cleaning.
(18) White or black lines on printouts.
N° Possible cause Solutions
1 You did not use recommended media. Use recommended media.
2 Media feed is incorrect Change the distance adjustment