User`s guide
Spitfire 100 Extreme series printers Users Guide
139 AP-75194 - Rev. 2.2
6.5.4.4 Media width menu
If media detection has not been performed during initialization, the width of the media is set here.
It can be set in the following ranges:
100 model: 210mm-2604mm
Notes
On the media width menu,
If a value larger than the width of the media has been set, media or the product may be
contaminated by the ink during printing.
If a value smaller than the width of the set media has been set, media may not be cut correctly.
Setup items Parameters Description
media width 100 model: 210mm -
<841mm> - 2604mm
To change media width by operating the following keys.
[F2] key: to increase the setup value.
[F4] key: to decrease the setup value.
[ENTER] key: to confirm the setup value
[CANCEL] key: to cancel the setup value
6.5.4.5 Print and wipe menu
Please note that print + wipe should be used very carefully and is by default not recommended in
combination with Mild Solvent Ink.
If you choose to recommend a user to use the print + wipe function, please also stress that the operator
needs to take extra care to keep the wipers clean.
Carrying out wiping with wipers that are covered with a layer of ink that is dried out may cause permanent
head damage.
Setup items
Parameters Description
Print and Wipe OFF No wiping during printing
High After printing 10 passes, wiping cycle will be performed.
Middle After printing 16 passes, wiping cycle will be performed.
Low After printing 22 passes, wiping cycle will be performed.
Very Low After printing 30 passes, wiping cycle will be performed.
- [CANCEL] key: To shift to the previous hierarchy menu.