User`s guide
Spitfire 100 Extreme series printers Users Guide
122 AP-75194 - Rev. 2.2
6.5.1.21 Media cut menu
Set media cut method after printing.
Setup items
Parameters Description
Media cutting Auto After printing has been completed, the media is sent to the media cut
position and is automatically cut.
Manual Feed media to the media cut position after printing.
Use regular cutting blades available from hardware stores.
Off No media feed after printing.
- When "Auto" has been selected, proceed to the Shortest Cut Length menu.
If "Manual" or "Off" has been selected, the screen changes to the menu of
the previous hierarchy.
Notes
For the situations shown below, the media cut settings are always changed to "Off" regardless
the previous settings.
± When "Take-up system" or Roll-up/roll off system is set for the media detection settings (Media
detection menu)
When using the media shown below, set the media cut setting to "Manual". If set to "Auto", the
following errors may occur :
± Cloth material: The cloth fiber is not completely cut.
± Media with glue: Glue will adhere to the cutting blade and decreases cutting performance.
6.5.2 Setup Menu 2/7
6.5.2.1 Printing mode menu
To perform various settings for Printing mode.
Setup items
Parameters Description
Print mode setup Print mode 1 For each setup value of Printing mode, four settings
of "Printing mode 1" - "Printing mode 4" can be set.
Print mode 2
Print mode 3
Print mode 4
- [CANCEL] key: to shift to the previous hierarchy
menu.