User`s guide

Spitfire 100 Extreme series printers  Users Guide
119 AP-75194 - Rev. 2.2
6.5.1.15 Heater D menu
Set the temperature of the Drier.
Setup items
Parameters Description
Heater D OFF  50°C Change drier temperature by operating the following keys.
 [F2] key: to increase the setup value.
 [F4] key: to decrease the setup value.
 [ENTER] key: to confirm the setup value
 [CANCEL] key: to cancel the setup value
6.5.1.16 HStatus menu
Check the temperature of the heating elements.
Press the [CANCEL] key to go to the previous menu.
Setup items Parameters Description
HStatus A: B: C: D: A, B, C, D = Heaters
O
means that heater is switched OFF
H
means that this heater is busy HEATING
C means that this heater is COOLING down
T means that this heater is ON TARGET (reached set temperature)
I
means that this heater group is initializing
E means that this heater group is inside Error
Amb. T Ambient temperature.
Heater Message Possible error messages will be displayed on the last line. For example:
Err. Temp rise A
-