User`s guide
Spitfire 100 Extreme series printers Users Guide
117 AP-75194 - Rev. 2.2
6.5.1.11 Thickness menu
To set the media thickness.
Setup items
Parameters Description
Thickness 50µm-<100µm>1500µm Change media thickness by operating the following keys.
[F2] key: to increase the setup value.
[F4] key: to decrease the setup value.
[ENTER] key: to confirm the setup value
[CANCEL] key: to cancel the setup value
Notes
Bidirectional quality can only be obtained when media thickness is set correctly.
6.5.1.12 Heater A menu
Sets the temperature of the Heater.
Setup items Parameters Description
Heater A OFF 50°C Change heater temperature by operating the following keys.
[F2] key: to increase the setup value.
[F4] key: to decrease the setup value.
[ENTER] key: to confirm the setup value
[CANCEL] key: to cancel the setup value
Use the [F2] or [F4] key to select the requested temperature for the Heater.
Notes
The default setting for the heater is set to 50°C.
The function of the heater (A): Warming the transfer paper before entering the pressure rollers.
The pre-expansion helps to minimize media cockling.