User`s guide

Spitfire 100 Extreme series printers  Users Guide
116 AP-75194 - Rev. 2.2
6.5.1.8 Head Height menu
Head height can be changed to three levels according to media thickness.
Setup items
Parameters Description
HeadHeight Low Make this setting when using media with a thickness of 80µm (0.08mm)
to 300µm (0.3mm).
Middle Make this setting when using media with a thickness of 300µm (0.3mm)
to 700µm (0.7mm).
High Make this setting when using media with a thickness of 700µm (0.7mm)
to 1000µm (1.0mm).
-
Notes
Set the height of the head in relation to the thickness of the media.
± If the setting is set to "High" and the print is created on thin media, good quality print results will not
be achieved.
If the setting is set to "Low" and thick media is used, the media and print head will come into
contact and may result in damage to the product.
6.5.1.9 Vacuum menu
Set the intensity of the vacuum fans.
Setup items Parameters Description
Vacuum Normal 100% of the capacity of the vacuum fans
Custom Adjustable from 0% to 100%
-
6.5.1.10 Fan Mode menu
With this function ALL fans or only the fans under the media will be activated.
Setup items Parameters Description
FanMode ALL To activate all fans under the print surface
Automatic To activate only the fans under the media
-