User`s guide

Spitfire 100 Extreme series printers  Users Guide
106 AP-75194 - Rev. 2.2
6.4 OPERATIONS AFTER PRINTING
6.4.1 Automatic Media Cutting
The media cutting procedure is described below.
Roll media is automatically cut after printing when "Auto" has been set on the cut media menu and roll media
has been set.
When the operation panel is in the normal status, and the product is in the following conditions, the media
can be cut on the desired position:
When roll media has been set:
If "OFF" has been set on the cut media menu
If "Take Up Roll" has been set in the media detection setup menu
When sheet media has been set
Step 1 : Make sure that the MEDIA SET lamp is off.
Step 2 : Press the [F1] key.
Shift to the cut and feed menu.
Step 3 : Feed media to the desired position according to the procedure in "Feeding media".
Step 4 : Press the [F1] key.
The media is cut at its position when the [ENTER] key has been pressed.
Notes
If the front edge of the roll media is not straight when you load new roll media, you should cut
its edge.
Cutting blades are consumable. Replace them at regular intervals following "Replacing the
cutting blade".