User`s guide
Spitfire 100 Extreme series printers Users Guide
100 AP-75194 - Rev. 2.2
6.2.3.2 Change the fixer temperature
To change the temperature of the fixer, press the [F2] key. The display will mention the following:
Press the [F2] key to decrease the temperature.
Press the [F4] key to increase the temperature.
Press the [ENTER] key to confirm the requested temperature change.
Press the [CANCEL] key to leave the menu without changing the heater settings.
6.2.3.3 Change the post fixer temperature
To change the temperature of the post fixer, press the [F3] key. The display will mention the following:
Press the [F2] key to decrease the temperature.
Press the [F4] key to increase the temperature.
Press the [ENTER] key to confirm the requested temperature change.
Press the [CANCEL] key to leave the menu without changing the heater settings.
6.2.3.4 Change the dryer temperature
To change the temperature of the dryers, press the [F4] key. The display will mention the following:
Press the [F2] key to decrease the temperature.
Press the [F4] key to increase the temperature.
Press the [ENTER] key to confirm the requested temperature change.
Press the [CANCEL] key to leave the menu without changing the rear heater settings.
6.2.3.5 Activate/ deactivate heaters.
In the second menu, press the [F1] key to activate or deactivate all heating elements.
In case the heating elements have been activated, the display will mention SET OFF. By pressing the [F4]
key you can deactivate the heating elements. The display will mention SET ON.
In case the heating elements have been deactivated, the display will mention SET ON. By pressing the
[F4] key you can activate the heating elements. The display will mention SET OFF.
Please note that after finishing a printing job (and no other print job has been sent to the printer the heating
elements will keep their temperature for approximately 6 minutes). After 6 minutes the heating elements are
powered OFF.