Specifications

Spitfire 100 Extreme series printers – Operation Instructions
CHAPTER 1: SAFETY INSTRUCTIONS
9
AP-77200, Rev. 1.1, 05/07/07
Safety Instructions
o Spitfire Mild Solvent Inks
• General information:
Symptoms of poisoning may even occur after several hours; therefore medical observation is
needed for at least 48 hours after the accident.
• After inhalation:
Supply fresh air. If required, provide artificial respiration. Keep patient warm. Consult doctor if
symptoms persist.
In case of unconsciousness, place patient stably in side position for transportation.
• After skin contact: the product normally does not irritate the skin.
• After eye contact: Rinse opened eye for several minutes under running water.
• After swallowing: ask for medical advice or consult doctor.
o Do not disassemble ink cassettes. Otherwise, ink may get in your eyes or on your skin.
o This product has been tuned for the use of Spitfire Mild Solvent Ink cassettes. If other manufacturers’
products are used, drawing results become faint or ink ends are not properly detected, and the warranty
will not cover (repairs will require a fee) any resultant breakdown.
o Be careful not to pinch your fingers when opening and closing the front cover.
o Follow the instructions below when connecting the network interface cable. Otherwise, electrical shock
or fire may occur.
• Do not touch the connector.
• Do not connect the network cable connector which has not the same specifications as the interface
board
o When cutting the roll media, be careful of the following. Incorrect handling can result in injury to the
hands and fingers from the razor blade.
• When holding the media, do not place fingers over the media cut groove.
• Move the razor blade slowly along the media cutting groove.
o Do not use thinner, benzene, alcohol or other active agents. Doing so may result in damage or paint
peeling from the casing.
o Be careful not to spill water inside the printer. Doing so may result in a short circuit.
o Be careful not to touch the heaters during or after operation. Doing so may result in burns.
o Only use Spitfire Mild Solvent Ink and appropriate cleaning liquid.
o Never open the covers fixed with screws. Doing so may result in electrical shock or a malfunctioning of
the printer.
o Do not touch the cutter blade. Doing so may result in bodily injury.
o Do not cut hard objects or drop the cutter. Doing so may damage or chip the cutter blade.
o Do not bend or pull the waste fluid tube. Doing so may cause that the waste fluid will leak out and
malfunction of the product.
o Do not touch the cleaning wiper or the head cap unit with bare hands. Use a dust free cloth and gloves
to clean.
o Do not tilt the printer, stand it against a wall or turn it upside down. Doing so may cause ink to leak
inside the printer. Movement after transport is also not covered by the warranty.
o When installing options, do not touch the elements on the circuit board. The elements on the boards can
be very hot and can cause burns.
o Have four or more people unpack and assemble the printer.
o Have two or more people transport the printer.