Specifications

Spitfire 100 Extreme series printers – Operation Instructions

CHAPTER 6: PRINTER MENU

AP-77200, Rev. 1.1, 05/07/07

Printer Menu

6.4 OPERATIONS AFTER PRINTING

The operations performed after printing, are described here.

6.4.1 Automatic Media Cutting

The media cutting procedure is described below.

Roll media is automatically cut after printing when "Auto" has been set on the cut media menu and roll media

has been set.

When the operation panel is in the normal status, and the product is in the following conditions, the media

can be cut on the desired position:

• When roll media has been set:

• If "OFF" has been set on the cut media menu

• If "Take Up Roll" has been set in the media detection setup menu

• When sheet media has been set

Follow the steps below to cut the media.

Step 1 : Make sure that the MEDIA SET lamp on the operation panel is off.

Step 2 : Press the [F1] key on the operation panel.

¾ Shift to the cut and feed menu.

Step 3 : Feed media to the desired position according to the procedure in "Feeding media".

Step 4 : Press the [F1] key on the operation panel.

¾ The media is cut at its position when the [ENTER] key has been pressed.

Notes

• If the front edge of the roll media is not straight when you load new roll media, you should cut its edge.

• Cutting blades are consumable. Replace them at regular intervals following "Replacing the cutting

blade".