Specifications

Spitfire 100 Extreme series printers – Operation Instructions

CHAPTER 6: PRINTER MENU

AP-77200, Rev. 1.1, 05/07/07

Printer Menu

6.2.3.1 Change the heater temperature

To change the temperature of one of the heaters, press the [F1-F4] key on the operation panel. The display

will mention the following:

Press the [F2] key to decrease the temperature.

Press the [F4] key to increase the temperature.

Press the [ENTER] key to confirm the requested temperature change.

Press the [CANCEL] key to leave the menu without changing the heater settings.

6.2.3.2 Activate/

deactivate heaters.

In the second menu, press the [F1] key to activate or deactivate all heating elements.

In case the heating elements are activated, the display will mention “SET OFF”. By pressing the [F4] key

you can deactivate the heating elements. The display will mention “SET ON”.

In case the heating elements are deactivated, the display will mention “SET ON”. By pressing the [F4] key

you can activate the heating elements. The display will mention “SET OFF”.

Please note that after finishing a printing job (and no other print job is sent to the printer the heating elements

will keep their temperature for approximately 6 minutes. After 6 minutes the heating elements are powered

OFF.

6.2.3.3 PrintStart

When you choose this option, printing will start immediately. However, the heaters will continue to warm up

in order to reach the requested temperature.

6.2.4 [F4] - Operating the pressure rollers

When you want to switch the up and down movement of the pressure rollers follow the steps below.

Step 1 : Press the [F4] key on the operation panel.

¾ The printer works as follows.

Status of the printer Operation after the [F4] key has been pressed

• The pressure rollers have been lowered

• The MEDIA SET lamp switches off.

• The pressure rollers are lifted

• The MEDIA SET lamp will switch on (orange).

• The pressure rollers have been raised.

• The MEDIA SET lamp switches on (orange).

• The pressure rollers are lowered.

• The MEDIA SET lamp will switch off.

Notes

You can also switch the up and down movement of the pressure rollers using the foot switch instead of the

operation panel.