Specifications

Spitfire 100 Extreme series printers – Operation Instructions
CHAPTER 6: PRINTER MENU
70
AP-77200, Rev. 1.1, 05/07/07
Printer Menu
F1
To select head
F2
To choose which head should be cleaned (ALL, head 1, 2, 3, 4, 5, 6, 7 or 8)
F3
Little, normal or a powerful cleaning?
- …….-
Selected heads
Step 2 : To define the heads which should be cleaned with the [F2] key and select them with the [F1]
key. To deselect one or more heads, select them again.
Step 3 : Press the [ENTER] key to start the cleaning procedure.
6.2.3 [F3] - Controlling the heater elements
If you want to change or check the heater elements, follow the steps below.
Step 1 : Press the [F3] key on the operation panel.
¾ The printer works as follows.
By pressing the [F1] key, you will have direct access to control or change the heater
temperatures.
After pressing the [F1] key in the normal status, the operation panel will mention the following:
The ‘heater message’ can be one of the following:
• Heater busy
• Heater ready
‘A’ stands for the heater.
‘B’ stands for the fixer.
‘C’ stands for the post fixer.
‘D’ stands for the dryer.
‘H’ stands for h
eating (heaters are heating up).
‘T’ stands for t
arget (heaters are on temperature).
‘C’ stands for cooling (heaters are cooling down).
’O’ stands for off (heaters are off).