Specifications

Spitfire 100 Extreme series printers – Operation Instructions

CHAPTER 3: BASICS

AP-77200, Rev. 1.1, 05/07/07

Basics

3.9.2 Transferring the printer

Following are instructions for transferring the printer.

(1) Before the transfer

Follow the steps below to transfer the printer.

Step 1 : Make sure the printer and winding system are switched OFF.

Step 2 : Make sure the head is in the right edge position (capping position).

Step 3 : Disconnect the power cables and all other cables.

Step 4 : Higher the 6 levelling feet.

Step 5 : Install the two transportation arms.

Step 6 : Transfer the printer.

Notes

The caster attached to the stand has been designed for transferring the printer during short distances.

(2) After the transfer

Follow the steps below to prepare the printer to be used after the transfer.

Step 1 : Make sure that you place the printer on an adequate place

Step 2 : Connect the power cable and other cables.

Step 3 : Perform a nozzle check to check if the printer head has clogged.

Step 4 : Perform a fine adjustment of image quality.

Step 5 : Check if the winding system is still well aligned.

Caution

Do NOT transport the printer to another room without contacting your local Authorized Mutoh

Dealer.