Specifications

Spitfire 100 Extreme series printers – Operation Instructions
CHAPTER 3: BASICS
33
AP-77200, Rev. 1.1, 05/07/07
Basics
3.5 REPLACING THE WASTE BOTTLE
Read following information on when and how to replace the waste bottle.
3.5.1 Replacement Time
Replace the waste bottle when the waste bottle is full. This is determined firmware wise.
3.5.2 Replacement Procedures
Follow the steps below to replace the waste bottle.
Step 1 : Check the following if the power of the printer is ON.
¾ Printer is not printing.
¾ Operation panel is in normal status.
¾ Media setting light on the operation panel is off.
Step 2 : Lower the waste ink tank tray.
Step 3 : Remove the waste ink bottle.
Step 4 : Replace the full one with an empty one (in-the-box) and empty the full one.
Notes
• Put the used waste bottle in a solvent resistant container and follow the local regulations when
disposing.
• The counter of the waste bottle will be reset from the moment the tray releases the sensor. So be sure
to empty the waste tank, otherwise it will overflow.
Step 5 : Replace the waste ink bottle and guide the waste ink tank tray back to its home position.
Step 6 : Following message will be displayed after replacement