Specifications

Spitfire 100 Extreme series printers – Operation Instructions

CHAPTER 3: BASICS

AP-77200, Rev. 1.1, 05/07/07

Basics

Step 18 : Forward the media until you can stick it to the core installed between the front roll units.

Make sure to have an equal tension on both sides of the media.

HINT

To ease the winding up of the media on the front core, it is permitted to cut the media in a V-shape.

Step 19 : Tighten the media straight to the core with tape.

Step 20 : After closing the front cover, the media initialize will start.

[F1]-key Lever UP

[F2]-key Browse trough the different profiles for

media measurement

[F4]-key Start media measurement using the

selected profile in the lower left corner

Step 21 : Set the winder (FRONT) unit to ACTIVE. The front tensioning system will be activated.

Step 22 : Install the media retainers if necessary as explained in one of the next chapters.

Step 23 : Installation of the media is completed.

Notes

With a small intervention it is possible to reverse your winding direction. Mount the twist cable between the

control box and the front motorized unit cable.

1 Normal winding direction

2 Twisted motor cable attached

Roll unit

Empty core

Front swingbar