Specifications

Spitfire 100 Extreme series printers – Operation Instructions
CHAPTER 3: BASICS
25
AP-77200, Rev. 1.1, 05/07/07
Basics
Step 12 : Use the foot-switch to release some media on the rear.
Step 13 : Load media through the rear swingbar, over the print platform, under the pressure rollers as
pictured below.
Outside printable Inside Printable
1
Roll unit
2
Media roll
3
Rear swingbar
4
Print platform and pressure rollers
Step 14 : Take the media on the front of the printer and pull until the rear tensioning system gently hits the
back of the machine. This to become an equal tension.
Step 15 : Lower the pressure rollers by pressing the F4 key or using the foot pedal.
Step 16 : Set the unwinder (REAR) unit to AUTOMATIC.
The rear tensioning system will go to its initial position.
Notes
Be sure to make the correct settings on the control panel of the winding system.
OUTSIDE or INSIDE
Step 17 : Decide which kind of media measurement should be done as described in the previous chapter.
Go to step 20 when you have chosen for OFF - Roll LeftRight or Roll LeftRightTop. When you have chosen
for Roll to Roll, go to step 18