Specifications

Spitfire 100 Extreme series printers – Operation Instructions
CHAPTER 2: PRODUCT OVERVIEW
11
AP-77200, Rev. 1.1, 05/07/07
Product Overview
2 PRODUCT OVERVIEW
2.1 PART NAMES AND FUNCTIONS
2.1.1 Front
No Name Function
1
Maintenance Area
To perform a part of the daily and weekly maintenance. For example cleaning around
the heads.
A mirror has been installed to optimize sight.
2
Paper Guide Support the media during printing.
3
Front cover
This cover keeps the operator safe from the drive parts of the printer while it is
operating. Only open and or close the cover to perform following operations.
• Media set and replacement
• Cutter blade replacement
• Cleaning the wipers and other maintenance
• In case of media jams
4
TL light switch To light up the TL lights (blue and white)
5
Operation panel
This panel is used to set operational conditions, the status of the printer and other
functions.
6
SmartChip Management
System
To control the ink volume on your printer
7
Ink compartment Sixteen slots available to install ink cassettes.
8
LED indicators Indicates if there is a cassette in the slot below the LED and if it is empty or not.
9
Waste bottle
To collect the waste fluid. Should be emptied according to the procedure described in
this manual.
10
Stand This stand is used to install the printer on a flat surface floor.
11
Unwinder/Winder PCB Box This box contains all electronics to control the unwinder winder 100 system.
12
Winder system Motorized roll-up system.
13
Unwinder/Winder control
panel
To control the complete unwinder/winder 100 system.
14
Front swingbar To adjust the tension of the media and to optimize the winding of the media.