User`s guide

Users Guide Viper Extreme
CHAPTER 5: Printer menu
60 AP-75330  Rev. 1.0  14/01/09
5.2.3 [F3] - Controlling the heater elements
If you want to change or check the heater elements, follow the steps below.
Step 1 : Verify the following regarding the condition of the printer.
It is not currently printing
Step 2 : Press the [F3] key of the operation panel.
To shift to the heater menu.
The heater message will be one of the following:
± Heater standby
± Heater warming up
± Heater ready
A heater.
D dryer.
S Set-temperature (requested temperature).
R Real-temperature (actual temperature).
5.2.3.1 Change the heater temperature
To change the temperature of the heater, press the [F1] key. The display will mention the following:
Press the [F2] key to decrease the temperature.
Press the [F4] key to increase the temperature.
Press the [ENTER] key to confirm the requested temperature change.
Press the [CANCEL] key to leave the menu without changing the heater settings.
5.2.3.2 Change the dryer temperature
To change the temperature of the dryers, press the [F4] key. The display will mention the following:
Press the [F2] key to decrease the temperature.
Press the [F4] key to increase the temperature.
Press the [ENTER] key to confirm the requested temperature change.
Press the [CANCEL] key to leave the menu without changing the rear heater settings.