User`s guide

Users Guide Viper Extreme
CHAPTER 5: Printer menu
58 AP-75330  Rev. 1.0  14/01/09
5.2 OPERATION PANEL IN STANDBY MODE
This section describes functions operated on the operational panel when the printer is in the normal status.
Notes
FOR INFORMATION OF THE NAME AND FUNCTION OF EACH KEY, REFER TO "OPERATION PANEL".
5.2.1 [F1]  Feeding, Cutting media and Step Adjust
When you want to feed media forward or backward, follow the steps below:
Step 1 : Verify the following regarding the condition of the printer.
It is currently not printing.
Step 2 : Press the [F1] key of the operation panel.
To shift to the Cut&Feed menu.
Step 3 : Press the [F3] key or the [F4] key.
The product will perform following operations:
Setup items Key name Parameters Description
Cut & Feed
F1 Cut Cut media
F2 Dist.Adj. Set step
F3 Forward Feeds media forward.
F4 Backward Feeds media backward.
Notes
IF "TAKE-UP ROLL" OR [ROLLFEED] HAS BEEN SET IN THE MEDIA DETECTION SETUP MENU, THE PRODUCT WILL NOT
OPERATE EVEN IF THE [F4] KEY HAS BEEN PRESSED.