User`s guide
Users Guide Viper Extreme
CHAPTER 4: Preparations before printing
52 AP-75330 Rev. 1.0 14/01/09
4.3.4 Printing flow
The following flowchart gives you a view on which steps must be taken to make a print. This is a very short
summary of what must be done.
SELECT MEDIA
(Refer to the media compatibility lists on www.mutoh.be)
LOAD MEDIA
(Refer to the chapter Loading Media)
PERFORM NOZZLECHECK AND CLEANINGS IF NECESSARY
(Refer to the chapter TestPrinting)
SELECT IMAGE
LOAD DEDICATED PROFILE
( )
AND RIP IMAGE
(Refer to profiles section on www.mutoh.be)
SET STEP
(Refer to chapter Set the correct distance adjust)
DECIDE WHICH WEAVING PATTERN TO USE (SIGN/PICTURE)
(Refer to chapter I² technology)
PRINT IMAGE
It is highly recommended to use one of the profiles Mutoh is making available on the website. A lot of parameters are included.
The most important ones are:
Ink an colour management related
Ink Restrictions
Linearization
Ink limits
ICC Profile
PrintMode related
Resolution
Amount of passes
Unidirectional Bi Directional
Weaving ON OFF
Media related
Heater settings
Media thickness
HeadHeight
The file name of most profile is build up as follows:
Viper Extreme_Mutoh_Highspeed_KCMYKCMY_360x360DDVarBI2P