User`s guide

Users Guide Viper Extreme
CHAPTER 3: Basics
38 AP-75330  Rev. 1.0  14/01/09
3.7 TRANSFER AND TRANSPORTATION
3.7.1 Transferring the printer
Follow the instructions below when you want to move the printer to another location (on the same floor).
Caution
KEEP THE PRINTER HORIZONTALLY DURING TRANSFER.
DO NOT TURN THE PRINTER UPSIDE DOWN. DOING SO WILL CAUSE INK LEAKING INSIDE THE PRINTER. ALSO,
THE WARRANTY DOES NOT COVER MOVEMENT AFTER TRANSPORT.
HAVE TWO OR MORE PEOPLE TO TRANSPORT THE PRINTER.
(1) Before the transfer
Notes
BE AWARE THAT THE FRONT SWINGBAR OF THE UNW/W 100 CAN ONLY BE LOCKED IF THE ETT IS NOT MOUNTED.
Step 1 : Power OFF the printer.
Step 2 : Make sure to switch OFF the Unwinder / Winder 100 system.
Step 3 : Make sure the head is in the right edge position (capping position).
Step 4 : Disconnect the power cable of the printer, winding system and all other cables.
Step 5 : Turn in the four feet of the printer.
Step 6 : Turn in the six feet of the Unwinder/Winder 100.
Step 7 : Transfer the printer to its new location.
Notes
THE CASTERS ATTACHED TO THE STAND HAVE BEEN DESIGNED FOR TRANSFERRING THE PRINTER FOR SHORT
DISTANCES.
(2) After the transfer
Follow the steps below to prepare the printer to be used after the transfer.
Step 1 : Make sure that you place the printer on an adequate place.
Step 2 : Turn out the 4 feet of the printer. The printer must be positioned stable and horizontal. (Use a
level)
Step 3 : Connect the power cable and other cables.
Step 4 : Perform a nozzle check to check if the printer head has clogged.
Step 5 : Perform a fine adjustment of image quality.