User`s guide
Users Guide Viper Extreme
CHAPTER 7: Troubleshooting
148 AP-75330 Rev. 1.0 14/01/09
7.4 WHEN MEDIA JAMS OCCUR
Be sure to read and understand the safety warnings before handling the printer.
7.4.1 How to remove a piece of media (cut media)
Step 1 : Press [F4] to raise the pressure rollers.
The MEDIA SET lamp will switch ON (orange).
The operation panel displays the following message.
Notes
For raising or lowering the pressure rollers, use the foot switch instead of the operation panel.
Step 2 : If a piece of media or media dust is stocked in the printer, open the front cover and remove the
piece of media or media dust.
Step 3 : If there is an error requiring a restart, power the printer OFF and ON again.
7.4.2 How to remove a piece of media (roll media)
To remove a piece of roll media, please refer to the Users Guide Handling roll media.