User`s guide

Users Guide Viper Extreme
CHAPTER 6: Periodical maintenance
129 AP-75330  Rev. 1.0  14/01/09
6.1.2 Three monthly maintenance
6.1.2.1 Replace the wipers
Step 1 : Power ON the printer and go to the WiperClean-Menu.
Step 2 : Press the [F2]-key to accept the carriage to move to the left side of the machine
Step 3 : Remove the old wipers with a pair of tweezers
Step 4 : Before inserting a new wiper, moisten the wiper with Water based Cleaning Liquid.
Step 5 : Insert the moistened wiper with a pair of tweezers.
Be sure to insert the wiper
correctly as shown below:
When standing in front of
the machine.
Be sure that the wiper clicks in the wiper
holder!
Step 6 : Close the front cover and press the [ENTER] key. The head will cap in.
Notes
Be careful not to break the lips of the wiper arm while installing the wipers.
Do not touch the wipers with your bare hands to avoid fat or dirt get in contact with the wipers and
automatically the nozzle plate. Use a pair of tweezers to avoid this. Clean wipers with appropriate
cleaning liquid in case of dirt.