Instruction manual

VJ-1604 QUICK REFERENCE

4 Daily maintenance 4-11

4 Daily Maintenance

NOTE

• If you fail to remove blurs or incompleteness of printing in one Head cleaning,

perform strong cleaning.

• If blurs or lacking parts in printed media do not disappear with several times of

Head cleaning, refer to "5 Troubleshooting", and take appropriate measures.

4.2.4 Cleaning the cleaning wiper

This sub-section describes the cleaning steps of the cleaning wiper.

(1) Cleaning time

Once a week, or when blurs or lacking parts appear on printed media after Head cleaning.

(2) Cleaning method

Follow the procedure below to clean the cleaning wiper.

NOTE

• Use the cleaning stick to clean the cleaning wiper.

For cleaning stick, refer to "8.3 Supply list" in the Operation Manual.

1. If the printer is turned ON, make sure the following.

• Printing or other operations are not in progress.

• The operation panel display is Normal.

2. Display the CR Maintenance menu on the operation panel.

a. Press the [Menu] key on the operation panel.

• "Menu 1: Setup>" is displayed on the operation panel.

• The operation panel shifts to the Setup menu display.