Instruction manual

VJ-1604 QUICK REFERENCE
2 Product overview 2-3
2 Product overview
2.1.2 Rear section
10 Maintenance cover Used to prevent the user from touching the inner mechanical section.
Open and close in the following cases.
• When cleaning the cleaning wiper
• When cleaning around the print head
It is normally closed.
11 Waste fluid valve Open and close when discharging the waste fluid from the waste fluid tank.
It is normally closed.
12 Adjuster Used to install the printer horizontally.
13 Media holder plate Installed inside of the front cover.
By attaching media holder plates to both sides of the media, it is possible to
prevent warpage.
No. Name Function
1 Roll media holders Used to load the roll media.
Include flanges where roll media is attached, and the levers that fix the roll
media holders.
2 Media feed slot Used for feeding media.
3 Ink cartridge slot Insert the ink cartridge.
4 Media guide Used for feeding media smoothly when the media is set or printed.
The heater (pre heater) to warm media is installed.
5 AC inlet Used for connecting the power cable.
6 USB connector Not used for this printer.
7 Network interface connector Connects a network interface cable.
No. Name Function
24
1
5 6 7 1
3